Dell PowerConnect 8024 - Boot Host Auto-Save; Boot Host Dhcp

Autoconfig Commands 877
57
Autoconfig Commands
This chapter explains the following commands:
• boot host auto-save
• boot host dhcp
• boot host retry-count
• show boot
boot host auto-save
The boot host auto-save command enables/disables the option to automatically save
configuration files downloaded to the switch by Auto Config.
Syntax
boot host auto-save
no boot host auto-save
Default Configuration
The downloaded configuration is not automatically saved by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines
Example
console#no boot host auto-save
boot host dhcp
The boot host dhcp command is used to enable/disable Auto Config on the switch.