Dell PowerConnect 8024 - Area Nssa Translator-Stab-Intv

OSPF Commands 733
Default Configuration
The default role is candidate.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator role of the NSSA.
console(config-router)#area 20 nssa translator-role always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPF Configuration mode to
configure the translator stability interval of the NSSA.
Syntax
area area-id nssa translator-stab-intv integer
no area area-id nssa translator-stab-intv
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or decimal from
0–4294967295)
•
integer — The period of time that an elected translator continues to perform its duties after it
determines that its translator status has been deposed by another router. (Range: 0–3600)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator stability interval of the area 20 NSSA.
console(config-router)#area 20 nssa translator-stab-intv 2000