Dell PowerConnect 8024 - Ipv6 Nd Other-Config-Flag

668 IPv6 Routing Commands
Syntax
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
• milliseconds — Interval duration. (Range: 0, 1000–4294967295)
Default Configuration
0 is the default value for milliseconds .
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval between router advertisements for advertised neighbor
solicitations at 5000 ms.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ns-interval 5000
ipv6 nd other-config-flag
Use the ipv6 nd other-config-flag command in Interface Configuration mode to set the “other
stateful configuration” flag in router advertisements sent from the interface.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.