Dell PowerConnect 8024 - Show Ip Dvmrp

DVMRP Commands 581
Default Configuration
Disabled is the default state.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following command enables DVMRP trap mode.
console#configure
console(config)#ip dvmrp trapflags
console(config)#no ip dvmrp trapflags
show ip dvmrp
Use the show ip dvmrp command in Privileged EXEC mode to display the system-wide
information for DVMRP.
Syntax
show ip dvmrp
Default Configuration
This command has no default condition.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays system-wide information for DVMRP.
console(config)#show ip dvmrp
Admin Mode..................................... Disable
Version........................................ 3