Dell PowerConnect 8024 - Password (User EXEC)

156 AAA Commands
Default Configuration
No password is specified.
Command Mode
Line Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies a password “mcmxxyyy” on a line.
console(config-line)# password mcmxxyyy
password (User EXEC)
Use the password command in User EXEC mode to allow a user to change the password for only
that user. This command should be used after the password has aged. The user is prompted to
enter the old password and the new password.
Syntax
password
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows the prompt sequence for executing the password command.
console>password
Enter old password:********
Enter new password:********
Confirm new password:********