Dell PowerConnect 8024 - Name; Primary

438 RADIUS Commands
name
Use the name command to assign a name to a RADIUS server. Use the "no" form of this
command to reset the name to the default.
Syntax
name servername
no name
servername — The name for the RADIUS server (Range: 1 - 32 characters).
Default Configuration
The default RADIUS server name is Default-RADIUS-Server.
Command Mode
RADIUS mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#radius-server host acct 3.2.3.2
console(Config-acct-radius)#name acct777
primary
Use the primary command to specify that a configured server should be the primary server in
the group of authentication servers which have the same server name. Multiple primary servers
can be configured for each group of servers which have the same name. When the RADIUS
client has to perform transactions with an authenticating RADIUS server of the specified name,
it uses the primary server that has the specified server name by default. If it fails to
communicate with the primary server for any reason, it uses the backup servers configured with
the same server name. These backup servers are identified as the “Secondary” type.
Syntax
primary
Default Configuration
There is no primary authentication server by default.