LLDP Commands 355
Syntax Description
lldp med transmit-tlv [
capabilities
] [
network-policy
] [
ex-pse
] [
ex-pd
] [
location
] [
inventory
]
no med lldp transmit-tlv [
capabilities
] [
network-policy
] [
ex-pse
] [
ex-pd
] [
location
] [
inventory
]
•
Capabilities
— Transmit the capabilities TLV
•
network-policy
— Transmit the network policy TLV
•
ex-pse
— Transmit the extended PSE TLV
•
ex-pd
— Transmit the extended PD TLV
•
Location
— Transmit the location TLV
•
Inventory
— Transmit the inventory TLV
Parameter Ranges
Not applicable. Command accepts keywords only.
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, the capabilities and network policy TLVs are included.
Example
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#lldp med transmit-tlv capabilities
console(config-if-1/g1)#lldp med transmit-tlv network-policies
lldp notification
Use the lldp notification command in Interface Configuration mode to enable remote data
change notifications. To disable notifications, use the no form of this command.
Syntax
lldp notification
no lldp notification
Default Configuration
By default, notifications are disabled on all supported interfaces.
To Next Page
Loading...
