Address Table Commands 171
•
seconds
— Time is the number of seconds. (Range: 10–1000000 seconds)
Default Configuration
300 seconds
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In this example the bridge aging time is set to 400.
console(config)#bridge aging-time 400
bridge multicast address
Use the bridge multicast address command in Interface Configuration mode to register MAC-
layer Multicast addresses to the bridge table and to add ports to the group statically. To
deregister the MAC address, use the no form of the bridge multicast address command.
Syntax
bridge multicast address {
mac-multicast-address
|
ip-multicast-address
}
bridge multicast address {
mac-multicast-address
|
ip-multicast-address
} [add|remove]
{ethernet
interface-list
|port-channel
port-channel-number-list
}
no bridge multicast address {
mac-multicast-address
|
ip-multicast-address
}
•
add
— Adds ports to the group. If no option is specified, this is the default option.
•
remove
— Removes ports from the group.
•
mac-multicast-address
— MAC multicast address in the format xxxx.xxxx.xxxx.
•
ip- multicast-address
— IP multicast address.
•
interface-list
— Separate nonconsecutive Ethernet ports with a comma and no spaces; use a
hyphen to designate a range of ports.
•
port-channel-number-list
— Separate nonconsecutive port-channels with a comma and no
spaces; use a hyphen to designate a range of port-channels.
Default Configuration
No Multicast addresses are defined.
To Next Page
Loading...
