Command Groups 97
Utility Commands
Auto Config
Captive Portal
show ip vrrp interface stats Displays the statistical information about each virtual
router configured on the switch.
PE
vrrp track interface Alters the priority of the VRRP router based on the
availability of its interfaces.
IC
vrrp track ip route Tracks route reachability. IC
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
boot host auto-save Enables/disables automatically saving the downloaded
configuration on the switch.
GC
boot host dhcp Enables/disables Auto Config on the switch. GC
boot host retry-count Set the number of attempts to download a configuration. GC
show boot Displays the current status of the Auto Config process. PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
authentication timeout Configures the authentication timeout. CP
captive-portal Enables the captive portal configuration mode. GC
http port Configures an additional HTTP port for captive portal to
monitor.
CP
https port Configures an additional HTTPS port for captive portal to
monitor.
CP
show captive-portal Displays the status of captive portal. PE
show captive-portal status Reports the status of all captive portal instances in the
system.
PE
block Blocks all traffic for a captive portal configuration. CPI
configuration Enables the captive portal instance mode. CP
enable Globally enables captive portal. CPI
Command Description Mode*
To Next Page
Loading...
