Dell PowerConnect 8024 - History; History Size

954 Line Commands
Example
The following example configures the interval that the system waits until user input is detected
to 20 minutes.
console(config)#line console
console(config-line)#exec-timeout 20
history
Use the history command in Line Configuration mode to enable the command history
function. To disable the command history function, use the no form of this command.
Syntax
history
no history
Default Configuration
The default value for this command is enabled .
Command Mode
Line Interface mode
User Guidelines
This command has no user guidelines.
Example
The following example disables the command history function for the current terminal session.
console(config-line)# no history
history size
Use the history size command in Line Configuration mode to change the command history
buffer size for a particular line. To reset the command history buffer size to the default setting,
use the no form of this command.
Syntax
history size number-of-commands
no history size