Dell PowerConnect 8024 - Ip Dhcp Snooping Log-Invalid

DHCP Snooping Commands 215
no ip dhcp snooping limit
• pps —The maximum number of packets per second allowed (Range: 0–300 pps).
•
seconds —The time allowed for a burst (Range: 1–15 seconds).
Default Configuration
The default maximum rate is 15 packets per second (pps).
The default burst interval is 1 second.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Examples
console(config-if-1/g1)#ip dhcp snooping limit none
console(config-if-1/g1)#ip dhcp snooping limit rate 100 burst
interval 1
ip dhcp snooping log-invalid
Use the ip dhcp snooping log-invalid command to enable logging of DHCP messages filtered
by the DHCP Snooping application. Use the “no” form of this command to disable logging.
Syntax
ip dhcp snooping log-invalid
no ip dhcp snooping log-invalid
Default Configuration
Logging of filtered messages is disabled by default.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.