Dell PowerConnect 8024 - Show Ipv6 Pimsm Interface; Show Ipv6 Pimsm Neighbor

IPv6 Multicast Commands 651
show ipv6 pimsm interface
Use the show ipv6 pimsm interface command to display interface config parameters. If no
interface is specified, all interfaces are displayed.
Syntax
show ipv6 pimsm interface [ vlan vlan-id ]
• vlan-id—A valid VLAN ID value.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pimsm interface vlan 6
Slot/Port...................................... vlan 6
IP Address.....................................
FE80::2FF:EDFF:FED0:2/128
Hello Interval (secs).......................... 30
Join Prune Interval (secs)..................... 60
Neighbor Count ................................ 0
Designated Router..............................
FE80::2FF:EDFF:FED0:2
DR Priority.................................... 1
BSR Border..................................... Disabled
show ipv6 pimsm neighbor
Use the show ipv6 pimsm neighbor command to display IPv6 PIMSM neighbors learned on the
routing interfaces.