Dell PowerConnect 8024 - Port; Priority

486 TACACS+ Commands
console(config-tacacs)#key 12
port
Use the port command in TACACS Configuration mode to specify a server port number.
Syntax
port [ port-number ]
• port-number — The server port number. If left unspecified, the default port number is 49.
(Range: 0–65535)
Default Configuration
The default port number is 49.
Command Mode
TACACS Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to specify server port number 1200.
console(tacacs)#port 1200
priority
Use the priority command in TACACS Configuration mode to specify the order in which
servers are used, where 0 (zero) is the highest priority.
Syntax
priority [ priority ]
• priority — Specifies the priority for servers. 0 (zero) is the highest priority. (Range: 0–65535)
Default Configuration
If left unspecified, this parameter defaults to 0 (zero).
Command Mode
TACACS Configuration mode