Dell PowerConnect 8024 - Dhcp L2 Relay Remote-ID; Dhcp L2 Relay Trust

DHCP Layer 2 Relay Commands 209
User Guidelines
There are no user guidelines for this command.
Example
console(config)#dhcp l2relay circuit-id vlan 340-350
dhcp l2relay remote-id
Use the dhcp l2relay remote-id command to enable setting the DHCP Option 82 Remote ID
for a VLAN. When enabled, the supplied string is used for the Remote ID in DHCP Option 82.
Use the "no" form of this command to disable setting the DHCP Option 82 Remote ID.
Syntax
dhcp l2relay remote-id remoteId vlan vlan-range
no dhcp l2relay remote-id remoteId vlan vlan-range
• remoteId —The string to be used as the remote ID in the Option 82 (Range: 1 - 128
characters).
Default Configuration
Setting the DHCP Option 82 Remote ID is disabled by default.
Command Mode
Global Configuration.
User Guidelines
There are no user guidelines for this command.
Example
console(config)#dhcp l2relay remote-id dslforum vlan 10,20-30
dhcp l2relay trust
Use the dhcp l2relay trust command to configure an interface to mandate Option-82 on
receiving DHCP packets.
Syntax
dhcp l2relay trust
no dhcp l2relay trust