Dell PowerConnect 8024 - Exec-Timeout

Line Commands 953
62
Line Commands
This chapter explains the following commands:
•exec-timeout
•history
•history size
•line
• show line
• speed
exec-timeout
Use the exec-timeout command in Line Configuration mode to set the interval that the system
waits for user input before timeout. To restore the default setting, use the no form of this
command.
Syntax
exec-timeout minutes [ seconds ]
no exec-timeout
• minutes — Integer that specifies the number of minutes. (Range: 0–65535)
•
seconds — Additional time intervals in seconds. (Range: 0–59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.