Dell PowerConnect 8024 - Show Ipv6 Pimsm Rphash

652 IPv6 Multicast Commands
Syntax
show ipv6 pimsm neighbor [ all | interface vlan vlan-id ]
• vlan-id —A valid VLAN ID value.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pimsm neighbor all
Slot/Port...................................... vlan 6
Neighbor Address...............................
FE80::200:FF:FE00:33
Up Time (hh:mm:ss)............................. 00:00:12
Expiry Time (hh:mm:ss)......................... 00:01:34
DR Priority.................................... 0
show ipv6 pimsm rphash
Use the show ipv6 pimsm rphash command to display which rendezvous point (RP) is being
selected for a specified group.
Syntax
show ipv6 pimsm rphash group-address
group-address
—Group IP address supported by RP.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode