Dell PowerConnect 8024 - Ip Vrrp Timers Advertise; Ip Vrrp Track Interface

868 Virtual Router Redundancy Protocol Commands
console(config-if-vlan15)#ip vrrp 5 priority 20
ip vrrp timers advertise
Use the ip vrrp timers advertise command in Interface Configuration mode to set the
frequency, in seconds, that an interface on the specified virtual router sends a virtual router
advertisement. Use the no form of the command to return the advertisement frequency to the
default value.
Syntax
ip vrrp vr-id timers advertise seconds
no ip vrrp vr-id priority
• vr-id — The virtual router identifier. (Range: 1-255)
•
seconds — The frequency at which an interface on the specified virtual router sends a virtual
router advertisement. (Range: 1-255 seconds)
Default Configuration
seconds has a default value of 1.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the frequency at which the VLAN 15 virtual router sends a virtual
router advertisement.
console(config-if-vlan15)#ip vrrp 5 timers advertise 10
ip vrrp track interface
Use the ip vrrp track interface command to alter the priority of the VRRP router based on the
availability of its interfaces. It is useful for tracking interfaces that are not configured for VRRP.
Only IP interfaces are tracked. A tracked interface is up if IP on that interface is up. Otherwise,
the tracked interface is down.
When the tracked interface is down or the interface has been removed from the router, the
priority of the VRRP router will be decremented by the value specified in priority argument.
When the interface is up for IP protocol the priority will be incremented by the priority value.