Dell PowerConnect 8024 - User Group

Captive Portal Commands 901
console#show captive-portal user 1
User ID........................................ 1
User Name...................................... user123
Password Configured............................ Yes
Session Timeout................................ 0
Group ID Group Name
-------- --------------------------------
1 Default
2 group2
user group
Use the user group command to associate a group with a captive portal user. Use the “no” form
of this command to disassociate a group and user. A user must be associated with at least one
group so the last group cannot be disassociated.
Syntax
user user-id group group-id
• user-id —User ID (Range: 1–128).
•
group-id —Group ID (Range: 1–10).
Default Configuration
A user is associated with group 1 by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#user 1 group 3