Dell PowerConnect 8024 Cli Reference Guide

532 802.1X Commands
User Guidelines
This command has no user guidelines.
Example
The following example enables periodic re-authentication of the client.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x re-authentication
dot1x system-auth-control
Use the dot1x system-auth-control command in Global Configuration mode to enable 802.1X
globally. To disable 802.1X globally, use the no form of this command.
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Default Configuration
The default for this command is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables 802.1X globally.
console(config)# dot1x system-auth-control
dot1x timeout quiet-period
Use the dot1x timeout quiet-period command in Interface Configuration mode to set the
number of seconds that the switch remains in the quiet state following a failed authentication
exchange (for example, the client provided an invalid password). To return to the default
setting, use the no form of this command.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries