QoS Commands 427
show policy-map
Use the show policy-map command in Privileged EXEC mode to display all configuration
information for the specified policy.
Syntax
show policy-map [
policyname
]
•
policyname
— Specifies the name of a valid existing DiffServ policy. (Range: 1-31)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Parameter Description
Interface The port of the interface. If displaying the global configuration,
this output line is replaced with a global configuration
indication.
Intf Shaping Rate The maximum transmission bandwidth limit for the interface
as a whole. It is independent of any per-queue maximum
bandwidth values in effect for the interface. This value is a
configured value.
Queue Mgmt Type The queue depth management technique used for all queues
on this interface.
Queue An interface supports
n
queues numbered 0 to (
n
-1).The
specific
n
value is platform-dependent. Internal egress queue of
the interface; queues 0–6 are available.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the
queue, expressed as a percentage. A value of 0 means
bandwidth is not guaranteed and the queue operates using
best-effort. This value is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission
using a strict priority or a weighted scheme. This value is a
configured value.
To Next Page
Loading...
