Dell PowerConnect 8024 Cli Reference Guide

726 Multicast Commands
show ip pimsm rp mapping
The show ip pimsm rp mapping command is used to display all group-to-RP mappings of which
the router is aware (either configured or learned from the bootstrap router (BSR)). If no RP is
specified, all active RPs are displayed. This command deprecates the show ip pimsm rp
candidate, show ip pimsm staticrp and show ip pimsm rp commands.
Syntax
show ip pimsm rp mapping [ rp-address ]
rp-address — An RP address.
Default configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ip pimsm rp mapping
Group Address.................................. 225.1.0.0
Group Mask..................................... 255.255.255.0
RP Address..................................... 1.1.1.1
origin......................................... Static
Group Address.................................. 225.2.0.0
Group Mask..................................... 255.255.255.0
RP Address..................................... 2.2.2.2
origin......................................... BSR

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries