Dell PowerConnect 8024 - Show Trapflags

1026 SNMP Commands
show trapflags
Use the show trapflags command to show the status of the configurable SNMP traps.
Syntax
show trapflags [ ospf | ospfv3 ]
ospf | ospfv3—Use this parameter to show detailed OSPF trap status information
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show trapflags
Authentication Flag............................ Enable
Link Up/Down Flag.............................. Enable
Multiple Users Flag............................ Enable
Spanning Tree Flag............................. Enable
user-view1 1.3.6.1.2.1.1.7 Excluded
user-view2 1.3.6.1.2.1.2.2.1.*.1 Included
console# show snmp views user-view1
Name OID Tree Type
----------- ----------------------- ----------------------------
user-view1 1.3.6.1.2.1.1 Included
user-view1 1.3.6.1.2.1.1.7 Excluded