Dell PowerConnect 8024 - Area Virtual-Link Dead-Interval

792 OSPFv3 Commands
Example
The following example prevents Summary LSAs from being advertised into the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPFv3 Configuration mode to create the OSPF
virtual interface for the specified
areaid and neighbor . Use the no area virtual-link command to
delete an OSPF virtual interface in an area.
Syntax
area areaid virtual-link neighbor-id
no area areaid virtual-link neighbor-id
• areaid — Valid OSPFv3 area identifier (or decimal value in the range of 0-4294967295).
•
neighbor-id — Identifies the Router ID or IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example creates the OSPF virtual interface for area 1 and its neighbor router.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2
area virtual-link dead-interval
Use the area virtual-link dead-interval command in Router OSPFv3 Configuration mode to
configure the dead interval for the OSPF virtual interface on the virtual interface identified by
areaid and neighbor .