IPv6 MLD Snooping Commands 639
• Max Response Time — Displays the amount of time the switch waits after it sends a query on
an interface, participating in the VLAN, because it did not receive a report for a particular
group on that interface. This value may be configured.
• Multicast Router Present Expiration Time — Displays the amount of time to wait before
removing an interface that is participating in the VLAN from the list of interfaces with
multicast routers attached. The interface is removed if a query is not received. This value may
be configured.
show ipv6 mld snooping groups
The show ipv6 mld snooping groups command displays the MLD Snooping entries in the
MFDB table.
Syntax
show ipv6 mld snooping groups [{vlan
vlan-id
| address
ipv6-multicast-address
}]
•
vlan_id
— Specifies a VLAN ID value.
•
ipv6-multicast-address
— Specifies an IPv6 Multicast address.
Default configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
To see the full Multicast address table (including static addresses) use the show bridge address-
table command.
Example
console#show ipv6 mld snooping groups
Vlan Ipv6 Address Type Ports
---- ----------------------- ------- ----------------------------------
1 3333.0000.0003 Dynamic 1/g1,1/g3
2 3333.0000.0004 Dynamic 1/g1,1/g3
2 3333.0000.0005 Dynamic 1/g1,1/g3
MLD Reporters that are forbidden statically:
To Next Page
Loading...
