Dell PowerConnect 8024 - Sntp Client Poll Timer

Clock Commands 917
Syntax
sntp broadcast client enable
no sntp broadcast client enable
Default Configuration
The SNTP Broadcast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables a Simple Network Time Protocol (SNTP) Broadcast client.
console(config)# sntp broadcast client enable
sntp client poll timer
Use the sntp client poll timer command in Global Configuration mode to set the polling time
for the Simple Network Time Protocol (SNTP) client. To return to the default settings, use the
no form of this command.
Syntax
sntp client poll timer seconds
no sntp client poll timer
• seconds — Polling interval. (Range: 64-1024 seconds, in powers of 2)
Default Configuration
The polling interval is 64 seconds.
Command Mode
Global Configuration mode
User Guidelines
If a user enters a value which is not an exact power of two, the nearest power-of-two value is
applied.