Dell PowerConnect 8024 - Area Nssa Translator-Role

788 OSPFv3 Commands
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the area 1 NSSA so that summary LSAs are not advertised
into the NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa no-summary
area nssa translator-role
Use the area nssa translator-role command in Router OSPFv3 Configuration mode to configure
the translator role of the NSSA. Use the no form of the command to remove the configuration.
Syntax
area areaid nssa translator-role {always | candidate}
no area
areaid nssa translator-role
• areaid — Valid OSPF area identifier.
•
always — Causes the router to assume the role of the translator the instant it becomes a
border router.
•
candidate — Causes the router to participate in the translator election process when it
attains border router status.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.