Dell PowerConnect 8024 - Ipv6 Ospf Cost

OSPFv3 Commands 801
no ipv6 ospf areaid areaid
• areaid — Is a 32-bit integer, formatted as a 4-digit dotted-decimal number or a decimal value.
It uniquely identifies the area to which the interface connects. Assigning an area id which
does not exist on an interface causes the area to be created with default values. (Range: 0-
4294967295).
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example defines the OSPF area to which VLAN 15 belongs.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf areaid 100
ipv6 ospf cost
Use the ipv6 ospf cost command in Interface Configuration mode to configure the cost on an
OSPF interface.
Syntax
ipv6 ospf cost cost
no ipv6 ospf cost
• cost — Cost for OSPF interface. (Range: 1-65535)
Default Configuration
10 is the default value of cost .
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.