236 Ethernet Configuration Commands
Syntax
clear counters [ethernet
interface
| port-channel
port-channel-number
]
•
interface —
Valid Ethernet port. The full syntax is:
unit/port
•
port-channel-number —
Valid port-channel index.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
In the following example, the counters for port 1/g1 are cleared.
console#clear counters ethernet 1/g1
description
Use the description command in Interface Configuration mode to add a description to an
interface. To remove the description use the no form of this command.
Syntax
description
string
no description
•
string
— Comment or a description of the port attached to this interface. (Range: 1 to 64
characters)
Default Configuration
By default, the interface does not have a description.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
