VLAN Commands 503
Ingress Filtering: Enabled
Acceptable Frame Type: Untagged
GVRP status: Disabled
Port 2/g19 is member in:
VLAN Name Egress rule Type
---- --------- ----------- -----
2921 Primary A untagged Static
2922 Community A1 untagged Static
show port protocol
Use the show port protocol command in Privileged EXEC mode to display the Protocol-Based
VLAN information for either the entire system or for the indicated group.
Syntax
show port protocol {
groupid
| all}
•
groupid
— The protocol-based VLAN group ID, which is automatically generated when you
create a protocol-based VLAN group with the
vlan protocol group
command.
•
all
— Enter
all
to show all interfaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the Protocol-Based VLAN information for either the entire
system.
console#show port protocol all
Group
Group Name ID Protocol(s VLAN Interface(s)
--------------- ----- ---------- ---- ------------------------
To Next Page
Loading...
