Dell PowerConnect 8024 - Ipv6 Mld-Proxy; Ipv6 Mld-Proxy Reset-Status

662 IPv6 Routing Commands
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-interval 5000
ipv6 mld-proxy
Use the ipv6 mld-proxy command to enable MLD Proxy on the router. To enable MLD Proxy
on the router, you must also enable multicast forwarding. Also, ensure that there are no other
multicast routing protocols enabled on the router. Use the “no” form of this command to
disable MLD Proxy.
Syntax
ipv6 mld-proxy
no ipv6 mld-proxy
Default Configuration
MLD Proxy is disabled by default.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld-proxy
ipv6 mld-proxy reset-status
Use the ipv6 mld-proxy reset-status command to reset the host interface status parameters of
the MLD Proxy router. This command is only valid when MLD Proxy is enabled on the
interface.