Dell PowerConnect 8024 - Asset-Tag

1068 System Management Commands
• show system power
• show system temperature
• show tech-support
•show users
•show version
•stack
•standby
•switch priority
•switch renumber
•telnet
• traceroute
asset-tag
Use the asset-tag command in Global Configuration mode to specify the switch asset tag. To
remove the existing asset tag, use the no form of the command.
Syntax
asset-tag [ unit ] tag
no asset-tag [ unit ]
• unit — Switch number. (Range: 1–12)
•
tag — The switch asset tag.
Default Configuration
No asset tag is defined by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the switch asset tag as “1qwepot.” Because the unit parameter
is not specified, the command defaults to the master switch number.
console(config)# asset-tag 1qwepot