766 OSPF Commands
show ip ospf database
Use the show ip ospf database command in Privileged EXEC mode to display information
about the link state database when OSPF is enabled. If parameters are entered, the command
displays the LSA headers. Use the optional parameters to specify the type of link state
advertisements to display.
Syntax
show ip ospf [
<area-id>
] database [{asbr-summary | external | network | nssa-external |
router | summary}][
ls-id
] [adv-router [
ip-address
] | self-originate]
•
area-id
— Identifies a specific OSPF area
for which link state database information will be
displayed.
• asbr-summary — Display the autonomous system boundary router (ASBR) summary LSAs.
• external — Display the external LSAs.
• network — Display the network LSAs.
• nssa-external — Display NSSA external LSAs.
• router — Display router LSAs.
• summary — Display the LSA database summary information.
• ls-id — Specifies the link state ID (LSID). (Range: IP address or an integer in the range of
0–4294967295)
•
adv-router
— Display the LSAs that are restricted by the advertising router. To specify a
router, enter the IP address of the router.
• self-originate — Display the LSAs in that are self-originated.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
Information is only displayed if OSPF is enabled.
To Next Page
Loading...
