Dell PowerConnect 8024 Cli Reference Guide

524 Voice VLAN Commands
Syntax
voice vlan { vlanid | dot1p priority | none | untagged | data priority { trust | untrust } | auth
{ enable | disable } | dscp
dscp }
no voice vlan
• vlanid — The voice VLAN ID.
•
priority — The Dot1p priority for the voice VLAN on the port.
•
trust— Trust the dot1p priority or DSCP values contained in packets arriving on the voice
vlan port.
•
untrust— Do not trust the dot1p priority or DSCP values contained in packets arriving on the
voice vlan port.
•dscp
— The DSCP value (Range: 0–64).
Default Configuration
The default DSCP value is 46.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g1)#voice vlan 1
console(config-if-1/g1)#voice vlan dot1p 1
console(config-if-1/g1)#voice vlan none
console(config-if-1/g1)#voice vlan untagged
show voice vlan
show voice vlan [interface {< unit/port > |all}]
Syntax
When the interface parameter is not specified, only the global mode of the voice VLAN is
displayed.
When the interface parameter is specified:
Voice VLAN Mode The admin mode of the voice VLAN on the interface.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries