IPv6 Access List Commands 313
Default Configuration
This command has no default configuration.
Command Modes
Global Configuration mode
Interface Configuration (Ethernet, Port-channel, VLAN) mode
User Guidelines
This command specified in 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode setting is applied to all interfaces.
Example
• The following example attaches an IPv6 access control list to an interface.
console(config-if-1/g1)#ipv6 traffic-filter DELL_IP6 in
• Bind the IPv6 ACL named myipv6acl to the physical interface 1/g1 in the outbound direction.
console(config-if-1/g1)#ipv6 traffic-filter myipv6acl out
• Bind the IPv6 ACL named myipv6acl to the LAG interface 1 in the outbound direction.
console(config-if-ch1)#ipv6 traffic-filter myipv6acl out
• Bind the IP ACL named myipacl to the VLAN interface 999 in the outbound direction.
• console(config-if-vlan999)#ipv6 traffic-filter myipv6acl out
show ipv6 access-lists
The show ipv6 access-lists command displays an IPv6 access list and all of the rules that are
defined for the IPv6 ACL. Use the [name] parameter to identify a specific IPv6 ACL to display.
Syntax
show ipv6 access-lists [name]
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
