Dell PowerConnect 8024 - Show Bridge Address-Table Static

Address Table Commands 179
Syntax
show bridge address-table count [vlan vlan |ethernet interface-number |port-channel
port-channel-number ]
• vlan — Specifies a valid VLAN, such as VLAN 1
•
interface — Specifies a valid Ethernet port
•
port-channel-number — Specifies a valid port-channel-number
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the addresses in the Forwarding Database:
console#show bridge address-table count
Capacity: 8192
Used: 109
Static addresses: 2
Secure addresses: 1
Dynamic addresses: 97
Internal addresses: 9
show bridge address-table static
Use the show bridge address-table static command in Privileged EXEC mode to display static
entries in the bridge-forwarding database.
Syntax
show bridge address-table static [vlan vlan ] [ethernet interface |port-channel port-channel-
number
]
• vlan — Specific valid VLAN, such as VLAN 1.
•
interface — A valid Ethernet port .