Dell PowerConnect 8024 - Show Captive-Portal Interface Client Status

Captive Portal Commands 897
console#show captive-portal configuration 1 client status
CP ID..................................... 1
CP Name................................... cp1
Client Client
MAC Address IP Address Interface Interface Description
-------------- --------------- --------- --------------------------------
0002.BC00.1290 10.254.96.47 1/g1 Unit: 1 Slot: 0 Port: 1 Gigabit
0002.BC00.1291 10.254.96.48 1/g2 Unit: 1 Slot: 0 Port: 2 Gigabit
show captive-portal interface client status
Use the show captive-portal interface client status command to display information about
clients authenticated on all interfaces or a specific interface.
Syntax
show captive-portal interface interface client status
• interface —A valid interface in unit/port format.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal interface client status
Client Client
Intf Intf Description MAC Address IP Address
------ ----------------------------------- ----------------- ---------------
1/g1 Unit: 1 Slot: 0 Port: 1 Gigabit 0002.BC00.1290 10.254.96.47
0002.BC00.1291 10.254.96.48
1/g2 Unit: 1 Slot: 0 Port: 2 Gigabit 0002.BC00.1292 10.254.96.49
1/g3 Unit: 1 Slot: 0 Port: 3 Gigabit 0002.BC00.1293 10.254.96.50