Dell PowerConnect 8024 - Show Arp Switch

304 IP Addressing Commands
Syntax
ipv6 gateway gateway-address
no ipv6 gateway
gateway-address —The gateway address in IPv6 global or link-local address format.
Default Configuration
There is no IPv6 gateway configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 gateway 2003::1
console(config)#no ipv6 gateway
show arp switch
Use the show arp switch command in Privileged EXEC mode to display the entries in the ARP
table used by the management interface.
Syntax
show arp switch
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
Note that this command only show ARP entries used by the management interface. It is
logically separate from the ARP table used by the routing interfaces. See the show arp command
for details on how to view ARP entries for the routing interfaces.