Dell PowerConnect 8024 - Passive-Interface Default

OSPF Commands 757
passive-interface default
The passive-interface default command enables the global passive mode by default for all
interfaces. It overrides any interface level passive mode. Use the “no” form of this command to
disable the global passive mode by default for all interfaces. Any interface previously configured
to be passive reverts to non-passive mode.
Syntax
passive-interface default
no passive-interface default
Default Configuration
Global passive mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface
passive-interface
Use the passive-interface command to set the interface as passive. It overrides the global passive
mode that is currently effective on the interface. Use the “no” form of this command to set the
interface as non-passive.
Syntax
passive-interface vlan vlan-id
no passive-interface vlan
vlan-id
• vlan-id — The vlan number
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPF Configuration mode.