Dell PowerConnect 8024 Cli Reference Guide

IGMP Snooping Commands 281
Syntax
show ip igmp snooping groups [vlan vlan-id ] [address ip-multicast-address ]
• vlan_id — Specifies a VLAN ID value.
•
ip-multicast-address — Specifies an IP Multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
To see the full Multicast address table (including static addresses) use the show bridge address-
table command.
Example
The example shows Multicast groups learned by IGMP snooping for all VLANs.
console>show ip igmp snooping groups
Vlan IP Address Ports
---- ----------- -------
1 224-239.130|2.2.3 1/g1, 2/g2
19 224-239.130|2.2.8 1/g9-g11
IGMP Reporters that are forbidden statically:
---------------------------------------------
Vlan IP Address Ports
---- ------------------ -------------------
1 224-239.130|2.2.3 1/g19
show ip igmp snooping interface
Use the show ip igmp snooping interface command in Privileged EXEC mode to display the
IGMP snooping configuration.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries