536 802.1X Commands
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
•
seconds
—
Time in seconds that the switch should wait for a response to an
EAP-request/identity frame from the client before resending the request.
(Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Example
The following command sets the number of seconds that the switch waits for a response to an
EAP-request/identity frame to 3600 seconds.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x timeout tx-period 3600
show dot1x
Use the show dot1x command in Privileged EXEC mode to display 802.1X status for the switch
or for the specified interface.
Syntax
show dot1x [ethernet
interface
]
•
interface
— A valid Ethernet interface.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
To Next Page
Loading...
