Dell PowerConnect 8024 Cli Reference Guide

402 QoS Commands
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition using the specified IP address and bit
mask.
console(config-classmap)#match dstip 10.240.1.1 10.240.0.0
match dstip6
The match dstip6 command adds to the specified class definition a match condition based on
the destination IPv6 address of a packet.
Syntax
match dstip6 destination-ipv6-prefix/prefix-length
• destination-ipv6-prefix —IPv6 prefix in IPv6 global address format.
•
prefix-length —IPv6 prefix length value.
Default Configuration
There is no default configuration for this command.
Command Mode
Ipv6-Class-Map Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-classmap)#match dstip6 2001:DB8::/32

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries