784 OSPFv3 Commands
• ipv6 ospf mtu-ignore
• ipv6 ospf network
• ipv6 ospf priority
• ipv6 ospf retransmit-interval
• ipv6 ospf transmit-delay
• ipv6 router ospf
• maximum-paths
•passive-interface
• passive-interface default
• redistribute
•router-id
•show ipv6 ospf
•show ipv6 ospf abr
•show ipv6 ospf area
• show ipv6 ospf asbr
• show ipv6 ospf database
• show ipv6 ospf database database-summary
• show ipv6 ospf interface
• show ipv6 ospf interface brief
• show ipv6 ospf interface stats
• show ipv6 ospf interface vlan
• show ipv6 ospf neighbor
•show ipv6 ospf range
• show ipv6 ospf stub table
• show ipv6 ospf virtual-link
• show ipv6 ospf virtual-link brief
area default-cost
Use the area default-cost command in Router OSPFv3 Configuration mode to configure the
monetary default cost for the stub area. The operator must specify the area id and an integer
value between 1-16777215. Use the no form of the command to return the cost to the default
value.
To Next Page
Loading...
