Dell PowerConnect 8024 - Show Ipv6 Mld Groups

680 IPv6 Routing Commands
Router Advertisement Suppress Flag............. Disabled
Prefix 3FF0:1236:C261::1/64
Preferred Lifetime............................. 10000
Valid Lifetime................................. 100000
Onlink Flag.................................... Enabled
Autonomous Flag................................ Enabled
console#show ipv6 interface brief
Oper.
Interface Mode IPv6 Address/Length
---------- -------- ---------------------------------
vlan3 Enabled FE80::2FC:E3FF:FE90:147/128
3FF0:1236:C261::1/64
loopback 1 Enabled FE80::2FC:E3FF:FE90:145/128
3FF0:C221:1234::1/64
loopback 2 Disabled
tunnel 1 Disabled 3FFE:1234::1/64 [TENT]
show ipv6 mld groups
The show ipv6 mld groups command is used to display information about multicast groups that
MLD reported. The information is displayed only when MLD is enabled on at least one
interface. If MLD was not enabled on any interfaces, there is no group information to be
displayed.
Syntax
show ipv6 mld groups { group-address | vlan vlan-id }
• group-address — The group address to display.
•
vlan-id — A valid VLAN id.
Default Configuration
There is no default configuration for this command.