Dell PowerConnect 8024 - Ipv6 Mld Snooping Groupmembership-Interval

634 IPv6 MLD Snooping Commands
Command Mode
Interface Configuration (Ethernet, port-channel) Mode.
VLAN Database Mode.
User Guidelines
This command has no user guidelines.
Example
console(config-vlan)#ipv6 mld snooping immediate-leave 4
ipv6 mld snooping groupmembership-interval
The ipv6 mld snooping groupmembership-interval command sets the MLD Group
Membership Interval time on a VLAN or interface. The Group Membership Interval time is the
amount of time in seconds that a switch waits for a report from a particular group on a particular
interface before deleting the interface from the entry. This value must be greater than the
MLDv2 Maximum Response time value. The range is 2 to 3600 seconds.
Syntax
ipv6 mld snooping groupmembership-interval [vlan-id] [seconds]
no ipv6 mld snooping groupmembership-interval [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
•
seconds — MLD group membership interval time in seconds. (Range: 2-3600)
Default Configuration
The default group membership interval time is 260 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-4/g1)#ipv6 mld snooping groupmembership-interval
300