Dell PowerConnect 8024 - Redirect-Url

892 Captive Portal Commands
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#protocol http
redirect
Use the redirect command to enable the redirect mode for a captive portal configuration. Use
the “no” form of this command to disable redirect mode.
Syntax
redirect
no redirect
Default Configuration
Redirect mode is disabled by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#redirect
redirect-url
Use the redirect-url command to configure the redirect URL for a captive portal configuration.
Syntax
redirect-url url
• url —The URL for redirection (Range: 1–512 characters).
Default Configuration
There is no redirect URL configured by default.