Dell PowerConnect 8024 - User Session-Timeout

Captive Portal Commands 903
User Guidelines
There are no user guidelines for this command.
Example
console(Config-CP)#user 1 password
Enter password (8 to 64 characters): ********
Re-enter password: ********
user session-timeout
Use the user session-timeout command to set the session timeout value for a captive portal user.
Use the “no” form of this command to reset the session timeout to the default.
Syntax
user user-id session-timeout timeout
no user user-id session-timeout
• user-id —User ID (Range: 1–128).
•
timeout —Session timeout. 0 indicates use global configuration (Range: 0–86400 seconds).
Default Configuration
The global session timeout is used by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#user 1 session-timeout 86400
console(config-CP)#no user 1 session-timeout