Dell PowerConnect 8024 - User Group Moveusers; User Group Name

Captive Portal Commands 909
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#user group 2
console(config-CP)#no user group 2
user group moveusers
Use the user group moveusers command to move a group's users to a different group.
Syntax
user group group-id moveusers new-group-id
• group-id —Group ID (Range: 1–10).
•
new-group-id —Group ID (Range: 1–10).
Default Configuration
There is no default configuration for this command.
Command Mode
Captive Portal Configuration mode
User Guidelines
The new group-id must already exist.
Example
console(config-CP)#user group 2 moveusers 3
user group name
Use the user group name command to configure a group name.
Syntax
user group group-id name name
• group-id —Group ID (Range: 1–10).
•
name —Group name (Range: 1–32 characters).