256 Ethernet Configuration Commands
ch40 Link Aggregate Down
ch41 Link Aggregate Down
ch42 Link Aggregate Down
ch43 Link Aggregate Down
ch44 Link Aggregate Down
ch45 Link Aggregate Down
ch46 Link Aggregate Down
ch47 Link Aggregate Down
ch48 Link Aggregate Down
Flow Control:Disabled
console#
The displayed port status information includes the following:
show statistics ethernet
Use the show statistics ethernet command in Privileged EXEC mode to display detailed
statistics for a specific port or for the entire switch.
Syntax
show statistics ethernet { <
unit
>/<
port-type
><
port
> | switchport }
•
unit
— Physical switch identifier within the stack. Values are
1-12
.
•
port-type
— Values are
xg
for 10 gigabit Ethernet port.
•
port
— port number. Values are 1-24 xg ports only.
Example: xg2 is the 10 gigabit Ethernet port 2.
Field Description
Port The port number.
Type The port designated IEEE shorthand identifier. For example 1000Base-T refers to 1000
Mbps baseband signaling including both Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Link State Displays the Link Aggregation status.
To Next Page
Loading...
