Dell PowerConnect 8024 - Priority

RADIUS Commands 439
Command Mode
RADIUS mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config-auth-radius)#primary
priority
Use the priority command in RADIUS mode to specify the order in which the servers are to be
used, with 0 being the highest priority.
Syntax
priority priority
• priority — Sets server priority level. (Range 0-65535)
Default Configuration
The default priority is 0.
Command Mode
RADIUS mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS server before executing this
command.
Example
The following example specifies a priority of 10 for the designated server.
console(config)#radius-server host 192.143.120.123
console(config-radius)#priority 10