Dell PowerConnect 8024 - Ip Pimsm; Ip Pimsm Bsr-Border

Multicast Commands 709
ip pimsm
The ip pimsm command is used to administratively enable PIM-SM multicast routing mode on
a particular router interface. Use the “no” form of this command to disable PIM SM on an
interface. This command deprecates the ip pimsm mode command.
Syntax
ip pimsm
no ip pimsm
Default Configuration
PIM-SM is disabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ip pimsm
ip pimsm bsr-border
The ip pimsm bsr-border command is used to prevent bootstrap router (BSR) messages from
being sent or received through an interface. Use the “no” form of this command to disable the
interface from being the BSR border.
Syntax
ip pimsm bsr-border
no ip pimsm bsr-border
Default Configuration
The interface is not enabled to send BSR messages by default.
Command Mode
Interface Configuration (VLAN) mode